ماژول کنترل دشارژ باتری مدل XH-M609

ماژول کنترل دشارژ باتری مدل XH-M609

XH-M609 DC7-80V Voltage Protection Module Lithium Battery Under voltage Low Power Disconnect Output Board

Parameter:

Product name: Battery over-discharge protection module

Product model: HCW-M635 or XH-M609

Power supply voltage: DC7-80V

Output voltage: equal to the supply voltage

Control accuracy: 0.1V

Power consumption: <1.5W

Use range: various storage batteries / lithium batteries

Net weight: 28g

Product size: 57 x 42 x 19mm

Set to stop below 12.5 V and start above 14 V:

Set the protection value:

press “+ 一次 once to display the protection value, double-click” + 〃 “, the decimal point flashes, and then press” +,-“to change the value to 12.5. After no operation for 3 seconds, the module will automatically save and exit the setting mode.

ماژول کنترل دشارژ باتری مدل XH-M609

Set the hysteresis value:

press “-〃 once to display the hysteresis value, double-click” -〃, the decimal point will flash, and press “+,-” to change the value to 1.5. After no operation for 3 seconds, the module will automatically save and exit the setting mode.

Set to stop below 10 V and start above 15.5 V:

Set the protection value:

press “+ 一次 once to display the protection value, double-click” + 〃 “, the decimal point flashes, and then press” +,-“to change the value to 12.5. After no operation for 3 seconds, the module will automatically save and exit the setting mode.

Set the hysteresis value: press “-〃 once to display the hysteresis value, double-click” -〃, the decimal point will flash, and press “+,-” to change the value to 1.5. After no operation for 3 seconds, the module will automatically save and exit the setting mode.

Reset:

When the power is off, press and hold both buttons at the same time, and then power on. At this time, “888” is displayed on the screen to indicate that the factory reset is successful.

Factory set protection value: 12V, return difference: 2V

ماژول کنترل دشارژ باتری مدل XH-M609

Scope of application:

Suitable for all electric two-wheel tricycle batteries in the applicable voltage range;

Car battery and new energy electric vehicle battery discharge protection;

Over-discharge protection of various batteries;

Solar, wind and other power supply systems.

Instructions:

When the new battery is used for the first time, the rated voltage value is close to the actual value, and the stop discharge voltage can be judged.

A reasonable discharge voltage value can be obtained according to the normal voltage calculation method of the battery.

When the old battery is used, the actual voltage value and the rated voltage value are quite different.

You need to measure the termination voltage value in actual use yourself.

Slow charging is usually used for battery charging (in the case of fast charging, the voltage and current are relatively large, but the
battery is easily damaged.)

The slow charging voltage is 1.2 times the rated voltage, and the charging current is adjusted to about 2/10 of the rated capacity current of the battery.

ماژول کنترل دشارژ باتری مدل XH-M609

For example, the charging voltage of a 6V50Ah battery is about 7.2 volts, and the charging current is adjusted to 10A.
Reference formula: charging voltage = rated voltage X1.2, charging current = rated current X0.2

Package includes:

1 x XH-M609 Battery over-discharge protection module

ماژول های مشابه ماژول کنترل دشارژ باتری مدل XH-M609: